Mobile: 18688976300 (Mr. Peng) 15222276387 (Mr. Bai)
Email: pengwl@honred.com
QQ: 176496342
Address:Building A1, Runteng Industrial Park, Shiyan Street, Bao'an District, Shenzhen
Through 2026 the Chinese passenger-car market kept pushing advanced driver assistance from premium trims into the 100,000-150,000 RMB band, and the domain controller moved from option to standard fitment. Production teams usually react by studying placement cycle time and burn-in capacity. The overlooked item is the dozen or so M1.6-M2.0 screws inside the housing: they hold the assembly together, they sit on the thermal path, and they decide whether the unit can be opened again for rework.
The value of a controlled fastening on a domain controller is split between assembly and the ability to take it apart again. Failures on these units tend to surface only after assembly: a void under a BGA, a damaged connector, a poorly seated thermal pad. End-of-line rework needs a station that can lift the lid without marking the PCB or the housing. Warranty returns arrive from the vehicle with unknown history, and water ingress, long-term vibration and aged sealant all shift the breakaway torque away from the value recorded at build. What both cases share is that the motion has to be controlled and recorded rather than felt by hand.
A tenth of a newton-metre on an M1.6 screw can be worth several degrees of junction temperature. Heat leaves the die through a pad or grease layer into the aluminium housing, and the thermal resistance of that layer depends strongly on pressure. Too little pressure leaves the pad under-compressed and the void fraction high; too much bends the PCB locally around each screw, loads the solder joints and can crack moulded parts. The torque window is therefore narrower than for a general-purpose fastener of the same size, and the pattern has to be tightened in stages, diagonally first and then stepped up to target. For lines that need to handle lid screws without stripping the whole unit, a small screw removal equipment built on a vertical three-axis gantry keeps the motion inside the Z stroke and avoids side load on the board.
The screw map on a domain controller is not a fixed pattern; it changes with compute tier and connector set. Mid and high trims on the same platform may share a PCB outline yet differ in lid openings, connector layout and shield count, so the screw count ranges from eight to sixteen. On a mixed line a fixed-point program will fail, and the station has to identify the model and the screw-present state first, then load the matching recipe. The hard part is not resolution but reflection: aluminium housings and shields are specular, and ring light tends to blow out the counterbore and wash out the cross recess. Beyond locating, an automatic vision screw removal machine has to judge before it acts, which is why light angle and camera height are calibrated together rather than swapping lenses.
On automotive parts the answer to reuse is usually no. Fasteners on vehicle-grade assemblies carry lot traceability. A screw that has been backed out has already seen one plastic deformation cycle and one pass of coating wear, so its friction coefficient differs from first fit and the same torque yields lower preload. Most OEMs scrap removed screws, fit new ones and record the disassembly count in the rework file, which turns segregation and counting into a station requirement rather than housekeeping. In the M0.8-M2.0 range a M0.8-M2.0 screw removal solution also has to fix bit diameter and pick-up method, because the gap between shield and connector is narrow enough that a slightly oversized bit will not enter, and a screw next to a tall component will not lift cleanly.
Only three measurable figures need to be on the acceptance sheet. Repeat positioning accuracy decides whether the bit lands in the recess. Peak torque capture with curve retention decides whether a single screw can be traced. Removal completeness decides whether a screw is left inside the housing. All three can be reproduced with a master sample at FAT instead of being discovered in volume.
Related Articles
/ RECOMMENDED NEWS